How to Replace Ceiling Sheetrock

如果您是房主,就有机会beplay平台没信用you’ll need to replace some drywall在某一点。墙很简单,但是呢天花板板岩?如果您发现自己需要替换天花板板岩,则可能会发现以下分步教程有所帮助。此特定实例也涉及阁楼接入点,可能适用也可能不适用于您的情况。

How to Replace Ceiling Sheetrock View in gallery

如何替换天花板板岩 - 如果您的天花板损坏 View in gallery

如果你的天花板损坏(这个例子包括a cracked PVC pipe in the attic, which warped the sheetrock and resulted in a ceiling cave-in), you’re going to need to replace it.

不仅在板岩上有一个洞 View in gallery

在这种情况下,不仅在板岩上有一个洞,而且周围的天花板板岩也有很多翘曲。那也必须替换。

孔发生在阁楼接入点旁边 View in gallery

此外,孔出现在阁楼接入点旁边,一开始就处于不良状态。

阁楼进入框架是一些旧的装饰件 View in gallery

阁楼接入框架是一些旧的装饰件,随着时间的流逝,它们在中心向下分开。

原始访问点不仅丑陋 View in gallery

原始访问点不仅丑陋, it was dangerous as well. That will be included in this ceiling sheetrock replacement.

How to Replace Ceiling Sheetrock- To begin repairing the ceiling sheetrock, View in gallery

To begin repairing the ceiling sheetrock, you’ll need to remove everything that will be replaced. This includes the attic access trim. Before you go any further, you’ll need to go up into the attic and remove any insulation from the sheetrock area to be replaced. If you don’t do this, you’ll have an even bigger mess, as all the insulation will fall down when you remove the entire sheetrock section.

After the insulation in the attic View in gallery

After the insulation in the attic has been taken care of (we just tossed ours to the sides so it could easily be brought back over the new sheetrock after replacement), it’s time to figure out just exactly where you’ll be replacing the ceiling sheetrock. Anytimeyou replace drywall,在干墙损坏后,您需要切割到下一个托梁(或在墙壁的情况下,在墙壁的情况下),但不超过一英寸。

Use a box cutter to cut along the center point of the joist View in gallery

Use a box cutter to cut along the center point of the joist. This will allow you to use drywall screws to secure the newly cut edge of the original sheetrock, if necessary, as well as provide a secure spot to screw the new sheetrock to.

沿着任何带有箱刀的角落,以防止油漆剥落 View in gallery

If applicable, you’ll also want to score (or cut, if it’s in the center of a large piece of sheetrock) along any corners with a box cutter to keep the paint from peeling off the wall as you remove the ceiling sheetrock.

请注意,这个得分的边缘的外观更干净 View in gallery

请注意,这个得分的边缘的外观更干净than the large patches of paint that ripped off with the original ceiling’s cave-in.

Remove all fixtures from the area View in gallery

卸下该区域的所有固定装置。此示例包括一个光和烟雾探测器。其他灯具可能包括通风口。

在这里,天花板的板岩已被删除 View in gallery

在这里,天花板的板岩已被删除。Although the hole was just a little more than a foot in diameter, the sheetrock to be replaced is a 3’x4’ rectangle, based upon the most logical replacement areas. In this space, measure and mark the positions of any fixtures that you will need to cut holes for in the new sheetrock piece.

Measure, mark, and cut with a box cutter the new sheetrock piece. View in gallery

Measure, mark, and cut with a box cutter the new sheetrock piece.

测量并标记任何固定装置的位置 View in gallery

如果适用,请测量并标记任何固定装置的位置。这些通常是4英寸的正方形,尽管您需要仔细检查天花板上的东西,以确保切割的孔的尺寸和形状正确。

用干墙锯切出孔。 View in gallery

用干墙锯切出孔。You may find it useful to drill a hole in a corner of your fixture marking, so you have a place for the saw to start.

Dry-fit the sheetrock onto the ceiling View in gallery

Dry-fit the sheetrock onto the ceiling, make any adjustments you need, then use 1-1/4” drywall screws to attach it to the joists. Take care not to screw down too hard; you want the ends of the original sheetrock and the new sheetrock to align horizontally (e.g., match in flatness). This will make for a much more seamless transition when it comes time to mud and tape the ceiling drywall.

helpful to make a pencil line along the center View in gallery

沿着板岩部分中间的任何托梁的中心制作铅笔线也很有帮助,因此您知道将螺丝放在哪里。在板岩中心和侧面的每个托梁上扔一些螺丝。

如何替换天花板石膏灰胶纸夹板——一旦你的新上海吗eetrock is in place View in gallery

如果适用,一旦您的新Sheetrock到位,就该更换阁楼访问框架了。此示例使用1×3板,并在框架上带有斜角。小心翼翼地离开约1英寸的悬垂(朝向接入点的中心),以便访问点胶合板“门”可以放在框架上。

It’s helpful to cut one piece to start View in gallery

切成一块开始,然后测量并切下下一件并安装它,然后移动到第三件,这很有帮助。(而不是一次切割所有四个零件。)确保木螺钉牢固地固定在托梁或2×4框架中;如果仅将框架固定到天花板干墙,它们将不会持久。

Use a Kreg Rip Cut attachment View in gallery

在上面使用kreg撕裂剪切附件your circular saw要将1/2英寸的胶合板板切成尺寸,以便您的阁楼进入,请注意饰边的各个侧面的1英寸悬垂物,以便胶合板足够大,可以放在那个悬垂物上。

取决于您的天花板板岩的大小 View in gallery

根据您的天花板板岩的大小,我们建议聘请专业人士来照顾泥泞,录音和纹理。这是非常实惠的,专业人士可以轻松地超过成本的好处。

For one thing the job gets done quickly with a professional View in gallery

For one thing, the job gets done quickly with a professional. Any wall peeled paint or other damage will get taken care of, and the wall will be restored to its original state.

A professional drywall installer will also be able View in gallery

如果您的切口不能与固定装置保持精确,那么专业的干墙安装程序也将能够轻松,准确地尺寸尺寸。

And a professional drywaller View in gallery

And a professional drywaller will get the new ceiling texture to match the original texture much better than the average DIYer. Although it probably won’t be precisely the same, it’ll be pretty close. With another coat of ceiling paint on that old texture, I think the transition will be pretty smooth.

professional also texture the access point View in gallery

我们的专业人士也像他做天花板一样质感胶合板“门”。绘画时,它通过走廊创造出无缝的外观和感觉。

如何更换天花板的板岩 - 阁楼访问的当代外观 View in gallery

我们现在喜欢阁楼访问框架的干净,现代外观。坦率地说,简单的线条比分开的弯曲装饰件要比分裂beplay平台没信用的弯曲装饰要好得多。

如何替换天花板的启动后的天花板和天花板 View in gallery

After priming and painting the ceiling and walls and letting them dry, it was easy to reinstall a new light and smoke detector.

如何更换天花板的板岩很难相信几天前 View in gallery

Hard to believe that a few short days ago, we had a gaping hole in our ceiling right here. The new ceiling sheetrock looks like it’s been there forever.

如何替换天花板板岩教程 View in gallery

We hope you find this tutorial helpful for how to replace ceiling sheetrock. Good luck with your efforts, and, as always, use care and good judgement in your DIY building adventures. Safety first.

Baidu